 |
TTL or CMOS logic output Set hysteresis to 100 mV Adjust trigger level to: 1. 1 V for 5 V TTL logic 2.5 V for 5 V CMOS logic 4.0 V for 12, 15 or 24 V CMOS logic |
3-wire active NPN open collector output Set hysteresis to 100 mV Adjust trigger level to -1 V |
2-wire passive magnetic pickup Set hysteresis to 10 mV for best low frequency response, to 100 mV for best noise rejection. Adjust trigger level to 0 V. A load resistor R may be required by the probe manufacturer. |
3-wire PNP open collector output Set hysteresis to 100 mV Adjust trigger level to -1 V |
2-wire NPN open collector output Set hysteresis to 100 mV Adjust trigger level to 2.5 V |
3-wire active NPN open collector output (activated <1 mA, deactivated >3 mA) Set hysteresis to 100 mV Adjust trigger level to 1.5 V |
Copyright 2003,
NEWPORT Electronics, Inc. All rights reserved.