|
|
NEWPORT's new wireless relative humidity transmitter features a stand-alone, compact, battery powered design that transmits measurements back to a host
receiver up to 120 m (400') away. When activated the wireless transmitter will transmit readings continuously at pre set time interval that was programmed
by the user during the initial setup. Each unit measures and transmits: Relative Humidity Reading, Ambient Temperature, RF Signal Strength and
Battery Condition to the receiver and is displayed on your PC screen in real time using the provided software. Each unit includes free software
that converts your PC into a strip chart recorder or data logger so readings can be saved and later printed or exported to a spread sheet file.
The UWRH is compatible with the UWTC-REC family of wireless receivers, which can accept signals from up to 48 wireless transmitters,
and display them on a PC. Receivers are available with optional display and analog output. An analog output can be used to interface with a process controller,
PLC or data acquisition device. Each unit includes free software that converts your PC into a monitor, chart recorder or data logger. Readings can be saved
and later printed or exported to a spreadsheet file.
Wireless Receivers
UWTC-REC1: 48-channel wireless receiver with USB
UWTC-REC2: 48-channel wireless receiver with USB and single analog output
UWTC-REC3: 32-channel wireless receiver/host with Ethernet
UWTC-REC4: 48-channel DIN rail mount wireless receiver with USB and four analog output signals
UWTC-REC6: economical single channel wireless receiver with single analog output
|
|
SPECIFICATIONS
Temperature Range: -17 to 49°C (2 to 120°F)
Accuracy: ±1°C (±1.8°F)
Relative Humidity Range: 2 to 98% RH
Accuracy: ±2.5% RH from 20 to 80% RH; ±3.5% RH below 20 and above 80% RH@ 25°C (76°F)
Operating Environment: -10 to 70°C (14 to 158°F)
Computer Interface: USB, for initial programming/set-up (one interface cable included with receiver)
Transmit Sample Rate: Programmable from 1 sec to 2 min
Radio Frequency (RF) Transceiver Carrier: ISM 2.4 GHz, direct sequence spread spectrum.
RF Output Power: 10 dBm (10 mW)
Range of RF Link:
Outdoor line of sight: up to 120 m (400')
Indoor/urban: up to 40 m (130')
RF Data Packet Standard: IEEE 802.15.4, open communication architecture
Software (Included Free): Requires Windows® operating system
Battery: One 3.6V lithium, 2.4 Ah capacity (AA) (included)
Battery Life (Typical): 1 year (at 1 sample/min reading rate @ 25 (77°F))
Data Transmitted to Host: Relative humidity, ambient temperature, RF transmit strength and battery condition
Dimensions: 100 L x 50 W x 25 mm H (without antenna) (4 x 2 x 1")
Weight: 70 g (2.46 oz)
|
|
|
|
† All dollar amounts on this site are shown in US currency.
Note: Comes with one 3.6 V lithium battery, programming software, measurement and logging software, mounting bracket and complete operator’s manual.
Note: Because of transmission frequency regulations, these products may only be used in the United States, Canada and Europe(please note CE compliance of the specific model for use in Europe).
Ordering Example: (1) UWRH-2 Wireless RH/temperature transmitter, (1) UWTC-REC1 48-channel wireless transmitter receiver = $538.19
|
|
|
|
|
Keywords: Wireless Relative Humidity/Temperature Transmitter, Relative Humidity, Relative Humidity Sensor, Relative Humidity Transmitter, Wireless, Relative Humidity, Wireless Relative Humidity
|
Back to top |
| |